Wind turbine controllers

Controller wind turbine GreenChip W3500S

Controller wind turbine GreenChip W3500S

    Manufacturer
  • GreenChip (Ukraine)
  • Voltage 12/24/36/48 v
  • Maximum current 50 amps ballast Working
  • power 2000 watt
  • Maximum power 3000 watt
  • Rated current battery charging 0-50 A (adjustable in menu)
  • Measured current rozryadki Battery 0-100
  • A battery charging Voltage 0-100 V (adjustable in menu)
  • Technology PWM (PWM)
  • Current consumption in standby mode controller 10 ma DateSheet
Count Price
From1шт8360грн
From2шт8110грн
Code: 46
шт.

Бесплатная доставка по Украине

Є в наявності

Переглянути відгуки (0)
With this product buy:

Wiring diagram of the wind generator controller Principle of operation controller wind turbine GreenChip W3500S.

The controller dynamically checks the battery charging current and voltage. When the battery is discharged, its resistance is low, and therefore, when charging, a large current (more than 1/10 of its capacity) can flow through it. Therefore, in the initial cycle of battery charging, the controller makes sure that the current does not exceed 1/10 of the battery capacity. As the battery charges, the resistance of the battery increases, the current decreases, and the voltage across the battery begins to rise.

The current adjustment would not be complete if we only regulated the battery charging current, imagine this situation we charge the battery for 60 amperes, the charging current accordingly set 6 amperes (1/10 capacity) everything is fine, but then we wanted to connect an inverter on the battery and he began to discharge the battery with a current of 13 amperes, it turns out that our battery, instead of being charged, will be discharged with a current of 7 amperes. Therefore, the controller implements control of the discharge current, when the wind generator controller sees that the external load (Inverter) consumes 13 amperes as in our case, then the controller increases the current from the wind generator to 19 amps, it turns out 6 amperes will go to the battery and 13 amps to the inverter.

The controller monitors that the voltage does not rise above the limit set in the menu. If the current or voltage exceeds the established norms, then the excess energy is thrown off to the ballast. The controller redirects all the extra energy that the wind turbine generates to the ballast (they can be heating elements whose power should be greater than the power of the wind turbine)

Important: Ballast must be selected so that when the battery is charged, the controller can load the wind turbine, otherwise it will go into gear.

Appearance of the controller for the W3500S wind turbine Instructions for the controller for the W3500S wind turbine

Reviews of the Controller wind turbine GreenChip W3500S: