Arduino > Remote control

ENC28J60 Ethernet Module for Arduino

ENC28J60 Ethernet Module for Arduino

Features:

  • built-in controller for converting the data into standard Ethernet - Microchip ENC28J60;
  • SPI interface with the conclusions of CLKOUT, WOL, SI, CS, VCC, INT, SO, SCK, RESET, GND;
  • RJ45 interface with data transfer rates up to 100 Mbit / s;
  • Model connector RJ45 HR911105A;
  • Supply Voltage: 3.3 V;
  • the operating frequency of 25MHz
  • module dimensions: 51 x 19 x 17 mm;
  • Weight: '11

Переглянути відгуки (0)

To use Ethernet module ENC28J60 for Arduino , you need to connect it to the Arduino-controller or other microprocessor control unit via an interface located on the motherboard. Then you need to write to the memory controller management software project.  

When the board is powered, should turn power LED. After that, the interface RJ45 network module can be connected to the network cable. If the connection to the RJ45 interface is installed should turn the LEDs indicate acceptance of sending packets (reception - green, sending - orange).

Ethernet module ENC28J60 for Arduino has two interfaces - SPI interface for Arduino controller or other microprocessor-based control device and RJ45 interface to connect the network cable.

SPI interface for Arduino-controller has 10 pins, which are designated CLKOUT, WOL, SI, CS, VCC, INT, SO, SCK, RESET, GND.

RJ45 interface has 8 pins to connect the network cable.

The maximum data rate of 100 Mbit / s.

Power network module is provided by Arduino controller or other microprocessor-based control device, and can also be powered from an external power source (power supplies, batteries). Power pins VCC and GND.

Ethernet module ENC28J60 for Arduino is designed to implement network applications: remote management system, network access, data publication.


Reviews of the ENC28J60 Ethernet Module for Arduino: