Polish controller Matek F405-STD
Physical
Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm
Firmware
ArduPilot: MatekF405-TE
INAV: MATEKF405TE
BetaFlight: MATEKF405TE Size: 36mm x 36mm x 5mm
Переглянути відгуки (0)
Matek F405-STD flight controller with built-in barometer
DESCRIPTION
The new version of the F405-STD flight controller from Matek. The main difference from the previous version F405-OSD, is the built-in BMP280 (I2C) barometer. It is compatible with the Matek FCHUB-6S / FCHUB-VTX / FCHUB-W power wiring board with a 16pin stub.
CHARACTERISTICS
MCU: F405 at 168 MHz STM32F405RGT6
Gyro chip: ICM20602 with 32kHz and 16kHz PID Loop / Accelerometer (SPI)
Barometer: BMP280 (I2C)
OSD: BetaFlight OSD with AT7456E chip
Blackbox: MicroSD card slot (SD / SDHC)
VCP, UART1, UART2, UART3, UART4, UART5
Built-in inverter for SBUS input (UART2-RX)
PPM / UART Shared: UART2-RX
SoftSerial on TX2, S5 or S6 (optional)
Camera control on S6 or DAC (optional)
SmartAudio & Tramp VTX protocol supported
Battery voltage sensor: 1:10
Current sensor: None (Optional FCHUB-6S, FCHUB-VTX, FCHUB-W)
BEC 5V: No (option FCHUB-6S, FCHUB-VTX, FCHUB-W)
LDO 3.3V: Max. 300mA
I2C1 SDA & SCL: Yes
WS2812 Led Strip: Yes
Beeper: Yes
RSSI: Yes
Loop: 16pin
Loop Length: 5cm
Fitting Holes: 30.5mm
Size: 36x36mm
Weight: 7g
COMPLETE
1x Matek F405-STD flight controller
1 x set of damper bolts under the controller
2x 16pin cable for power distribution board connection
