Radiomaster R88 Multi Protocol Prioner

Binding method: Radiomaster R88 Multi Protocol

1. Press and hold the BIND button on the receiver, then connect power. After about 3 seconds the LED will turn RED, the receiver is now in bind mode.

2. Select the D8 protocol for your remote's multiprotocol menu and press the [BIND] option, the receiver's red LED will flash, indicating successful binding.

3. Exit bind mode on the remote control and power off the receiver, then power on the receiver again. The LED will now turn solid RED, indicating that binding is complete. If not, repeat steps 1 and 2.

Fail-safe protection:

1. Press the BIND button once within 10 seconds of turning the receiver on, and the receiver will store all current remote control channel values as a safety value.

2. The BIND button function will be disabled 10 seconds after the receiver is turned on to prevent accidentally changing the failsafe settings while preparing the model for flight.

RSSI Output:

This receiver has a total of 9 channels. 8 channels + RSSI output channel.

Channels 1-8 are controlled by the remote control, channel 9 is the RSSI signal strength value output by the receiver itself, which can be read by the flight controller and sent to the OSD.