DC6-28V ZS-X12H 0-100W brushless motor speed controller
- Product parameters:
- Product name: Three-phase DC brushless with Hall drive
- Model: ZS-X12H (with hall)
- Operating voltage: 6-28 V (30 V limit)
- Drive current: nominal 3.5 A, peak 4 A
- Current limit protection and locked rotor protection: current limit protection when the current exceeds 4A and the motor rotor is locked for 5 seconds to protect against shutdown
Переглянути відгуки (0)
DC6-28V ZS-X12H 0-100W brushless motor speed controller
Notes on the product:
1. This is a three phase brushless DC driver with Hall driver board. The motor must have a Hall and connect the line sequence to work properly.
2. Because the forward and reverse rotation is a hard switching without delay and high-speed braking, the impact will be strong, so these two functions cannot be operated at high voltage and full speed, and the speed control accelerator must be reduced to 50% or lower. Yes, forced operation may damage the power tube and chip
3. The power of this module is small (up to 100W) and the overload capacity is weak. It should be used with a margin. It is not allowed to be connected to a high-power motor for operation or test machine. Power operation may cause damage to the power pipe. It is recommended to use 12V power supply within 42W, 24V power supply within 84W.
4. This drive is a low power brushless fan with Hall drive, and it can also be integrated into other systems. It is specially used for air pumps, water pumps, oil pumps, fans, etc. and small space industrial electric motors and three-phase small power DC brushless motors. Small tools, etc. are not suitable for high-power motors, such as long-term full-load operation, it is recommended to strengthen heat dissipation
5. The power supply circuit on the main board is missing a fuse. It is recommended to add one yourself. Reversing the positive and negative poles of the power supply will cause irreversible damage to some chips on the board (even for 1 second).
