LM393 Hall Sensor Module for Arduino
Features:
- Type - Hall sensor
- Built on the chip LM393
- Operating Voltage: DC 5V
- The output of the low-level
- Adjustable sensitivity (fine tuning)
- Size: 32x11x20 mm
- Size: 32mm x 11mm x 20mm
Переглянути відгуки (0)
LM393 Hall Sensor Module for Arduino is a magnetic field sensor, which works on the principle of Hall effect
The sensor is constructed on the chip LM393.
The low level output when a sensor.
The board LM393 module is a red LED - light sensor response.
The output of the sensor can be connected directly to the microcontroller.
Connection interface LM393 module Hall sensor for Arduino
- GND - earth
- VCC - Power supply: 5V
- OUT - digital output (output of the comparator)
There are mounting holes for easy installation.
LM393 Hall Sensor Module for Arduino can be used as proximity switches, for contactless measurement of current in the conductors, motor control, reading magnetic codes, liquid level measurement (magnetic float), etc.
Also LM393 sensor module can be used to determine engine speed, position, etc.