Wind turbine controllers

Controller  wind turbine GreenChip WS4000S

Controller wind turbine GreenChip WS4000S

    Manufacturer
  • GreenChip (Ukraine)
  • Voltage 12/24/36/48 v
  • Maximum current 100 amps ballast
  • Built-in three-phase rectifier - no Working
  • power 4000 watt
  • Maximum power 5000 watt
  • Rated current battery charging 0-50 A (adjustable in menu)
  • Measured current discharge of Battery 0-100
  • A battery charging Voltage 0-100 V (adjustable in menu)
  • size 300*120*70 mm
  • Technology PWM (PWM)
  • Current consumption in standby mode controller 10 ma
Count Price
From1шт5328грн
From2шт5062грн
Code: 42
шт.

Бесплатная доставка по Украине

Переглянути відгуки (0)

We are glad to present to your attention the GreenChip WS4000S wind generator controller.

GreenChip WS4000S Wind Generator Controller dynamically checks the battery charging current and voltage. When the battery is discharged, its resistance is low, and therefore, when charging, a large current (more than 1/10 of its capacity) can flow through it. Therefore, in the initial cycle of battery charging, the controller makes sure that the current does not exceed 1/10 of the battery capacity. As the battery charges, the resistance of the battery increases, the current decreases, and the voltage across the battery begins to rise.

The current regulation of the Greenchip WS4000S wind generator controller would not be complete if we only regulated the battery charging current, imagine this situation, we charge the battery for 60 amperes, the charging current, respectively, set 6 amperes (1/10 capacity), everything is fine, but here we wanted to connect the inverter to the battery and it began to discharge the battery with a current of 13 amperes, it turns out that our battery, instead of being charged, will be discharged with a current of 7 amperes. Therefore, the controller implements control of the discharge current, when the wind generator controller sees that the external load (Inverter) consumes 13 amperes as in our case, then the controller increases the current from the wind generator to 19 amps, it turns out 6 amperes will go to the battery and 13 amps to the inverter.

The GreenChip WS4000S wind generator controller ensures that the voltage does not rise above the limit set in the menu. If the current or voltage exceeds the established norms, then the excess energy is thrown off to the ballast. All excess energy generated by the wind turbine is redirected by the controller to the ballast (they can be heating elements whose power should be greater than the power of the wind turbine)

Important: The ballast must be selected so that when the battery is charged, the controller can load the wind turbine, otherwise it will run out of gear.

GreenChip Wind Generator Controller WS4000S Wind Generator Controller Wind turbine controller

Reviews of the Controller wind turbine GreenChip WS4000S: