SD3 biaxial solar tracker drive
Features: SD3 biaxial solar tracker drive
- The rated operating voltage is 24V.
- Load power (W): 90%
- Solar energy (W): 40%
- Operating time (hour): 24 hours
- Tightening torque: 400 Nm
- Torque of torque: 500 Nm
- Holding time: 2KN.m
- Static axial rating: 30KN.m
- Static radial rating: 15KN.m
- Dynamic Axial Rating: 9.6KN.m
- Dynamic radial rating: 8,4KN.m
- Material: 42CrMo 50Mn
- Transfer rate: 62: 1
- feedback - Hall sensors
- 360 degree angle
- the recommended control controller of the solar tracker
| Count | Price | |||
|---|---|---|---|---|
| From | 1 | шт | 63700 | грн |
| From | 2 | шт | 62426 | грн |
Переглянути відгуки (0)
We are glad to present to your attention the SD3 biaxial drive solar tracker.
SD3 2-axis solar tracker drive is a slewing drive used to rotate the solar tracker in two axes, which helps the tracker handle without unnecessary actuator.
SD3 biaxial drive of the solar tracker operates from a 24 Volt power source, and also has a relatively low current consumption.
SD3 biaxial solar tracker drive has high power and is also resistant to loads and weather conditions.
SD3 biaxial drive of the solar tracker has hall sensors on board for feedback with the solar tracker controller, which makes it possible to track changes in its position through the solar tracker control unit and makes it easier to control its operation.
To control the SD3 rotation, the biaxial drive of the solar tracker uses a powerful 42CrMo 50Mn slewing bearing, which is also installed on crane equipment, so that the reliability of the device and resistance to loads are ensured.
SD3 dual axis solar tracker drive delivers high transmission power of 62 to 1.
