Arduino > H-bridge

TB6560 stepper motor driver

TB6560 stepper motor driver

Characteristics:
  • Power supply: 10 - 35 V DC
  • Opto-isolated input control signals
  • Current: 0.3 - 3 A, 3.5 A peak
  • divider step (microstep): 1, 2, 8, 16
  • Protection: Low voltage, over temperature and over-current
  • Operating temperature: -10 ~ 45 ℃
  • size: 75 x 50 x 33 mm
  • Weight: 83 g
Count Price
From1шт396грн
From2шт385грн
From7шт373грн
Code: 649
шт.
Є в наявності

Переглянути відгуки (0)

TB6560 stepper motor driver is a driver of bipolar stepper motors. At the entrance of STEP-DIR control, that is one ping given by the direction of rotation, the second pin counts steps.

It is possible to use microstep and some adjustment of operating current.

All the settings are TB6560 stepper motor driver run or external components (resistors and capacitors) or by setting logic levels on certain legs:

  • Set the rated current. Adjustable resistors on the legs 14 and 11 respectively to the windings A and B.  
  • Set the operating current. There are four combinations, depending on levels and with legs TQ1 TQ2 (2 and 1 respectively).  
  • Work frequency PWM (PWM). Sets the external capacitor.  
  • microstepping modes. Expose level combination on legs M1 and M2. Variants - a step half step, 1/8 step and 1/16 step per pulse STEP.  
  • Decay mode - current suppression mode. Exhibited as operating current levels on the legs and Dcy1 Dcy2 (25 and 24 respectively).

Complete control system stepper motor, other than TB6560 stepper motor driver , must contain stepper drives, DC power source and a controller.


Reviews of the TB6560 stepper motor driver: