HC-06 Bluetooth radio transceiver module for Arduino

HC-06 Bluetooth radio transceiver module for Arduino


  • Bluetooth V2.0
  • Operating voltage: 3.3 V
  • User-defined data transfer rate: 1200, 2400, 4800, 9600, 19200, 38400, 57600 and 115200
  • A normal serial port settings: 9600, N, 8, 1
  • Password: 1234
  • Suitable for: mice, keyboards, joysticks, computer and peripherals; GPS receivers, and industrial control  
  • Dimensions: 2.7 cm x 1.3 cm x 0.1 cm
  • Weight: 5 g
198 грн
Code: 128

Переглянути відгуки (0)

HC-06 Bluetooth radio transceiver module for Arduino is a transceiver for wireless communication. It is simple to use and fully staffed. Bluetooth Module HC-06 You can use the device to send and receive data through the TTL Bluetooth without having to connect the serial cable to the computer.

Module HC-06 operates in passive mode, that is, you want to specify a search on the control (Master) device (laptop, mobile phone) and search for the device. After that, the master device will be the serial port, and all that will be sent to him, will appear on your Arduino, and vice versa - whatever Arduino will send you will be taken on your computer. If necessary, you can adjust the parameters of the module using AT commands.

The pinout:

  • STATE - here duplicated signal from the built-in LED when the module is active LED flashes when the connection is established - lights.
  • RXD - Pina on this module receives the data (ie, in your sketch here it is necessary to send data)
  • TXD - here module sends data
  • GND - earth
  • VCC - 3.3V
  • EN - on / off, you apply here a logical unit (or 5V), the module will shut down if a logic zero (or simply do not connect this pin) will work.

You may want to adjust some parameters of the module, such as its name, data rate, pin-code.

Wireless Bluetooth HC-06 module for

  • mouse,
  • keyboard,
  • joystick,
  • computers,
  • peripherals,
  • GPS- receiver,
  • industrial control.

Reviews of the HC-06 Bluetooth radio transceiver module for Arduino: