Programmers device

PicKit 3 programmer + ZIF-board for the PICkit 2 (PICkit 3)

PicKit 3 programmer + ZIF-board for the PICkit 2 (PICkit 3)

Features PicKit 3 programmer:
  • Interface HID.
  • Support for Windows 7 system.
  • Full speed 12 Mbit / s over USB
  • How to debug in real time
  • MPLAB IDE compatible (free copy included)
  • Built-in over-voltage / short circuit monitor
  • Ability to update the firmware to the PC download from the Internet  
  • Supports voltage range (2 - 6v)
  • mode - Programmer-to-Go - autonomous controllers programming PIC programs up to 512K bytes;
  • Diagnostic LEDs (power, busy, error)  
Features ZIF-board for the PICkit 2 (PICkit 3):
  • Direct connection type (no wires)
  • Type DIP adapter universal  
  • Compatible with chips in buildings: DIP6, DIP8, DIP14, DIP16, DIP20, DIP24, DIP28, DIP32, DIP40.  
  • Lead Spacing: 2,54mm.  
  • The distance between the rows of pins: 5 mm to 17.5 mm.
Price:
1056 грн
Code: 316
шт.
Очікуєм

Переглянути відгуки (0)

PICkit 3 programmer is a USB-programmer (maximum speed of 12 Mbit / s interface, the host computer).

The programmer provides read / write programs and data in the memory of the microcontroller.

PICkit 3 programmer debug in real time.

It has a built-in circuit over-voltage / short monitoring.

Software Update for PICkit 3 programmer is done with a PC via the Internet.

PICkit 3 programmer allows you to program Internally almost all Flash microcontrollers Microchip.

Learn more about PICkit 3 programmer can be read here .

PicKit3 - in-system programming. But not all are equipped with in-circuit board ICSP interface and do not always have the opportunity to place it on the board for such purposes to the programmer will need an adapter for external flash microcontrollers.

ZIF-board for the PICkit 2 (PICkit 3) is designed to work in conjunction with the popular PICkit 2 programmer (PICkit 3).

The programmable chip in the DIP from 8 to 40 pins are set in a universal ZIF-panel. Each of the 40 pins ZIF-panel connected to two pin connector for switching signals, connect the pins, etc. In ZIF-board for the PICkit 2 (PICkit 3) has a connector for an external power supply, crystal, LED.

The output connector is fully consistent with PICkit 2 programmer connector (3) and also Yu.P. pin connector.

Based on the PICkit 3 in-circuit programmer and ZIF-board for the PICkit 2 (PICkit 3) You can create a compact device with the help of which you can program in almost any microcontroller in DIP- package.

When the MC should pay attention to the fact that the microcontroller in the panel is positioned so that the key was on the chip side of the locking lever ZIF-panel.


Reviews of the PicKit 3 programmer + ZIF-board for the PICkit 2 (PICkit 3) :